My worst London session habit used to be doing this arithmetic in my head at 7:58 in the morning. The Asian box was drawn, the buffer was “about five pips”, the stop was “somewhere below the lows”, and the position size was whatever felt right. One morning that vagueness cost me 1.4% on a single breakout — nearly a third of my daily loss limit — because the box was 74 pips wide and I had sized for a 40-pip box. The London Breakout Calculator at the top of this page exists so I never do that again: you give it the session box high and low, your buffer, and your risk budget, and it hands back the entry, the stop, the 1R/2R/3R targets and the exact lot size. If you have not read the strategy behind it yet, start with my London breakout strategy guide — this calculator is the arithmetic engine for those rules.
In this article
What the Calculator Computes
The London open breakout has five moving numbers: the box, the entry buffer, the stop, the targets, and the size. Most traders get four of them right and guess the fifth — usually the size, which is the one that kills funded accounts. This tool locks all five together from the same inputs, so nothing is guessed. Enter the box high and low from your Asian/London range, pick the pip size for the pair, and set your buffer — the few pips beyond the box edge where your entry triggers, far enough to dodge wick fakes but close enough that the stop stays honest.
The outputs follow the strategy rules directly. Entry sits at the box edge plus your buffer in the breakout direction. The stop sits at the opposite box edge minus the buffer — the full box is your invalidation, because a breakout that falls back through the whole box was never a breakout. Targets are R multiples of the stop distance: 1R, 2R and 3R, so the plan is asymmetric by construction. And the lot size comes from your risk budget divided by the stop distance, which means a wide box automatically means a smaller position — the calculator enforces the discipline I used to skip.
The same maths powers my trend pullback strategy — the breakout plan that trades yesterday’s daily high and low instead of the session box. The calculator above accepts those day-level lines as inputs too, so one tool plans both breakouts.
The Breakout Formula
Box size (pips) = (Box high − Box low) ÷ Pip size
Long entry = Box high + (Buffer × Pip size) | Long stop = Box low − (Buffer × Pip size)
Stop distance (pips) = |Entry − Stop| ÷ Pip size
Lots = (Account × Risk %) ÷ (Stop distance × Pip value per lot)
TP at nR = Entry ± (n × Stop distance × Pip size)
Worked: GBPUSD box 1.2734 / 1.2660 = 74 pips, 5-pip buffer, long → entry 1.2739, stop 1.2655, stop distance 84 pips. $100,000 × 0.5% = $500 risk → 500 ÷ (84 × $10) = 0.60 lots. 1R = 84 pips → TP1 1.2823, TP2 1.2907, TP3 1.2991.
One Box, Worked End to End
A real morning from my journal. Asian range on GBPUSD: high 1.2734, low 1.2660 — a 74-pip box, slightly wide but workable. My buffer is 5 pips, account $100,000, risk 0.5% ($500). The calculator’s plan: entry 1.2739, stop 1.2655 (84 pips), 0.60 lots, TP1 at 1.2823 (+$500), TP2 at 1.2907 (+$1,000), TP3 at 1.2991 (+$1,500).
| Stage | What happened | P&L |
|---|---|---|
| 07:58 London | Price pushes through 1.2734, entry fills at 1.2739 | — |
| 08:40 | Momentum carries to 1.2823 — TP1, half off | +$250 (half position) |
| 09:15 | Pullback to 1.2775, stop moved to break-even on the runner | — |
| 10:20 | Second leg to 1.2907 — TP2, rest closed | +$500 (runner at 2R) |
| Total | Plan executed, no improvisation | +$750 (1.5R blended) |
The morning that taught me the buffer lesson was the mirror image: I used a 2-pip buffer on a similar box, got wicked in and out for −$500 before the real breakout ran 200 pips without me. The 5-pip buffer costs a slightly worse entry on the winners and saves a full stop on the fakeouts — that asymmetry is the whole point, and it is why the buffer is an input here rather than a fixed number.
Buffer and Session Rules That Make It Work
| Rule | My setting | Why |
|---|---|---|
| Entry buffer | 5 pips majors, 10 pips XAUUSD | Dodges wick fakes at the box edge without moving the entry far |
| Box hours | Asian range 00:00–07:00 GMT for the London break | Full session rules in the Asian range breakout guide |
| Max box width | Skip if the box is wider than ~1.5× the pair’s average session range | A giant box means a giant stop, which means dust-sized positions or broken risk |
| News blackout | No entries 30 min either side of red-folder news | News breaks boxes in both directions and stops both sides |
| One direction | Take the first clean break only; no reversing into the failed side | Reversal entries are a different strategy — I trade those with the pin bar reversal rules |
| Daily budget | Trade risk + open risk ≤ personal daily stop | Full routine in the risk-per-trade guide |
When the Calculator Tells You to Skip
The most useful output of this calculator is not a number — it is the moments it argues against the trade. If the stop distance is wider than 1.5× the box, something is off with the buffer or the box, and the honest move is to skip. If the risk percentage creeps above 1%, the calculator flags it, because no breakout is good enough to be worth 2% on a funded account. And if the box is so wide that the resulting position rounds down to almost nothing, the trade’s expectancy does not justify the screen time — there will be another box tomorrow. A calculator that only says “go” is a cheerleader; this one is a risk manager.
Questions Traders Ask About the London Breakout Calculator
What pip size should I use for gold?
Use 1 for XAUUSD (gold moves in whole dollars per pip on most prop firm feeds), 0.1 for indices, 0.01 for JPY pairs, and 0.0001 for other majors. The calculator formats all prices to match.
Why is the stop at the opposite box edge instead of just below the entry?
Because the box is the invalidation. A breakout that falls back through the entire range was a fakeout, and your stop should be where the idea is proven wrong — not at an arbitrary distance that price noise can reach.
Should I take all three targets or just TP1?
My rule: half off at TP1, move the stop to break-even, and let the runner work toward TP2/TP3. On a funded account, banking the first R and removing the risk is worth more than squeezing the full 3R on every trade.
Can I use this for the New York breakout too?
Yes — the maths is identical. Draw the box over the pre-New York range (the London morning consolidation) and run the same inputs. The buffer may need widening on high-impact news days, which is exactly when you should be most careful.
How is this different from the Asian range breakout?
Same family, different box: this calculator plans the London break of the overnight range, while the Asian range breakout strategy trades the Asian session’s own box. The session characteristics explain why each window behaves differently.
Risk disclaimer: breakout trading on a funded or personal account involves substantial risk of loss. Fakeouts are frequent, past box behaviour does not predict the next session, and no calculator replaces position sizing inside your daily loss limit. This tool is educational, not financial advice.







